How to use waterproof membrane punching machine? -Huaqiang Electronic Network

How to use waterproof membrane punching machine?
Waterproof membrane punching machine use:

ZSY-7 type punching machine selects the corresponding cutter according to different samples, and installs it on the punching machine

Upper platen position. Place the material on the knife pad to move the screw down, and the cutter is in contact with the material. Rotate the control knob in the direction of the sample and tighten it. Move the joystick with your hand and down to move the lower pressure plate upward. After the pressure is completed, turn the control knob to the reset direction, and the lower pressure plate automatically resets.
Waterproof membrane punching machine installation instructions:

1

When the machine is installed, lay the foundation and find the level with m8 expansion bolts.

2. Gently place the cutter on the bottom of the stamping column under the screw. The punching column is equipped with a super-strong magnet to stabilize the cutter. It is quick to install and easy to adjust.

3

When the test piece is stamped, it should be equipped with hardwood or rubber plate on the workbench to prevent damage to the knife edge.
Waterproof roll film processor

Precautions for use: After the experiment is completed, the surface should be cleaned, the lead screw and the stamping column should be coated with anti-rust grease, and the protective cover should be covered.