1) Usage example
Figure 1 uses the logic coil drive instructions
(2) Precautions for use
1) LD is the normally open contact at the beginning of the circuit connected to the left bus.
2) LDI is the normally closed contact at the beginning of the circuit connected to the left bus.
3) OUT is the drive coil output command, and input relay X cannot use this command.
4) In the ANB and ORB instructions described in *, LD and LDI can be used for the start contact of the serial and parallel circuit *.
5) For the timer, the counter coil must be set to a constant after the OUT command.
KNL6,KNL8 Residual Current Circuit Breaker
KNL6,KNL8 Moulded Case Circuit Breaker is MCCB , How to select good Molded Case Circuit Breaker suppliers? Korlen electric is your first choice. All moulded Case Circuit Breakers pass the CE.CB.SEMKO.SIRIM etc. Certificates.
Moulded Case Circuit Breaker /MCCB can be used to distribute electric power and protect power equipment against overload and short-current, and can change the circuit and start motor infrequently. The application of Moulded Case Circuit Breaker /MCCB is industrial.
Korlen electric also provide Miniature Circuit Breaker /MCB. Residual Current Circuit Breaker /RCCB. RCBO. Led light and so on .
KNL6,KNL8 Molded Case Circuit Breaker,Small Size Molded Case Circuit Breaker,Electrical Molded Case Circuit Breaker,Automatic Molded Case Circuit Breaker
Wenzhou Korlen Electric Appliances Co., Ltd. , https://www.korlen-electric.com